With snow storm warnings comes lower temperatures, simply being prepared and informed may help you to avoid the messy and often expensive issue of frozen pipes. Here are some tips and tricks on how to prevent water pipes from freezing, and how to thaw them if they do freeze.
Why Pipe Freezing is a Problem
Water expands as it freezes. This expansion puts tremendous pressure on whatever is containing it, including metal or plastic pipes. No matter the “strength” of a container, expanding water can cause pipes to break.
Preventing Frozen Pipes
Before the onset of cold weather, prevent freezing of these water supply lines and pipes by following these recommendations:
Drain water from swimming pool and water sprinkler supply lines following manufacturer’s or installer’s directions.
Do not put antifreeze in these lines unless directed.
Remove, drain, and store hoses used outdoors.
Close inside valves supplying outdoor hose bibs and open the outside hose bibs to allow water to drain.
Keep the outside valve open so that any water remaining in the pipe can expand without causing the pipe to break.
During Cold Weather, Take Preventative Action
Keep garage doors closed if there are water supply lines in the garage.
Open kitchen and bathroom cabinet doors to allow warmer air to circulate around the plumbing. Be sure to move any harmful cleaners and household chemicals up out of the reach of children.
When the weather is very cold outside, let the cold water drip from the faucet served by exposed pipes. Running water through the pipe – even at a trickle – helps prevent pipes from freezing.
Keep the thermostat set at the same temperature both during the day and at night. By temporarily suspending the use of lower nighttime temperatures, you may incur a higher heating bill, but you can prevent a much costlier repair job if pipes freeze and burst.
If you will be going away during cold weather, leave the heat on in your home, set to a temperature no lower than 55° F.
To Thaw Frozen Pipes
If you turn on a faucet and only a trickle comes out, suspect a frozen pipe. Likely places for frozen pipes include exterior walls or where your water service enters your home through the foundation.
Keep the faucet open. As you treat the frozen pipe and the frozen area begins to melt, water will begin to flow through the frozen area. Running water through the pipe will help melt ice in the pipe.
Apply heat to the section of pipe using an electric heating pad wrapped around the pipe, an electric hair dryer, a portable space heater (kept away from flammable materials), or by wrapping pipes with towels soaked in hot water. Do not use a blowtorch, kerosene or propane heater, charcoal stove, or other open flame devices.
Apply heat until full water pressure is restored. If you are unable to locate the frozen area, if the frozen area is not accessible, or if you cannot thaw the pipe, call a licensed plumber.
Check all other faucets in your home to find out if you have additional frozen pipes. If one pipe freezes, others may freeze, too.
Consider relocating exposed pipes to provide increased protection from freezing. Add insulation to attics, basements and crawl spaces. Insulation will maintain higher temperatures in these areas.
Always contact a water damage restoration professional that can clean up any water damage related to frozen pipes breaking. In Plainview, NY, you can contact ACE restoration for all your water damage restoration needs.